After two years of intensive research and development, it was time to elevate the spectrum of Gyeon ceramics to a new level: introducing a reEVOlution in the chemical group of polysilazanes, Gyeon managed to nearly double the durability and also simplify the application process: the wiping time has been drastically extended with the new EVO formulations.

Furthermore: all the new EVO ceramics no longer require a two-layer application, but just a single layer, and moreover, they can even be applied outdoors in clean air; a garage is no longer a mandatory requirement. The only thing to ensure is a dry place for the next 12 hours and some shade for the application.

Ceramic ProtectionGyeon Q2 Matte EVO Light, 50ml is a polysilazane-based ceramic sealant specially developed for matte paints and films. It is extremely hydrophobic and, especially, extremely easy to apply due to its slightly thicker consistency.

With just one layer, maximum performance is already achieved in terms of self-cleaning power and water cleaning capacity; the original matte appearance is not affected in any way by the completely neutral finish.

Durability: >24 months or 30,000km

Consumption: 30 ml/vehicle

Instructions for applying ceramic protection:

1. You must wash the car very well, using the two-bucket method.
2. Remove any bitumen or tar spots on the exterior of the car, using dedicated solutions.
3. Decontaminate the entire exterior of the car using decontamination clay and lubricant.
4. Rinse the exterior and dry it.
5. Degrease the exterior using Isopropyl Alcohol.
6. Start applying the ceramic protection in small sections (40 x 40 cm), leave it for 10 - 20 seconds and then wipe it off.

Attention: read the manufacturer's instructions, use protective equipment (gloves, mask as needed).

Recommendation: before applying the ceramic protection, we recommend applying a paint cleaner or a polish. Any scratch on the paint will remain after applying the ceramic protection.

Contents: 

1 x Gyeon Q2 Matte Evo Ceramic Protection, 50ml